1060 'Regeneration fault'

Multiple inadmissibly high currents in the regeneration branch
Device
Description
Class	Error
Drive Behaviour
Device Behaviour
Additional Error Information (AMK Service)

Error removal	Loose power terminals Power defect, check line voltage system Read out additional info with F2 key The diagnostic message can only be reset by power supply OFF/ON

Device	KE
Description
Class	Error
Drive Behaviour
Device Behaviour
Additional Error Information (AMK Service)
	Info 1	1	Short-circuit of the mains inverter BPH (HW) Interrupt (< 10 μs) regeneration is stopped and after min. 10 ms new start attempted
		3	Wrong state of switching pattern of IGBT (SW)
		5	Switching pattern of IGBT longer than 8 ms (SW) Regeneration is stopped and after min. 10 ms new start attempted
		9	New start of regeneration impossible Error message after 3 s
Error removal	Error can be cleared once

Fault line regeneration inverter (n)
Device	ZWR
Description	Inadmissible high current in the regeneration path
Class	Error
Device Behaviour	Automatic error reset and switch back on
Additional Error Information (AMK Service)

Error Removal	Check inverter -U1 Retighten terminal clamps -U1.X01:L1.1/L2.1/L3.1 if necessary