[X12] motor PTC thermistor connection

NOTICE

Material Damage!

Material damage resulting from Overheating!

AMK servo motors are provided with sensors for temperature monitoring. Motors without or with bypassed sensors for temperature can overheat and be destroyed.

Steps to prevent:

  • Connect the sensors for temperature of the servo motor for temperature monitoring
  • Activate the I²t monitoring of the servo motor in ID32773 'Service bits' Bit 14.

 

NOTICE

Material Damage!

Material damage caused by incorrect handling!

Mechanical damage to terminals!

Disconnected signal lines.

Steps to prevent:

  • The plug connectors are partially encoded. Do not push in with force.
  • Never pull on the cable, but rather on the connector casing.
  • For service purposes, use the control tap.

 

Description:

Connection for monitoring temperature of a servo motor.

Technical data:

Configurable via ID34166 'Temperature sensor motor'

Version:

Type

Pins

Connector with spring connection

2

Assignment:

[X12]

Connection

Signal

Description

front view, device side

1

RT1 (+)

Connection temperature sensor, take care of the polarity at KTY!

2

RT2 (-)

Connection temperature sensor, take care of the polarity at KTY!
Connection:

Recommended
cable type

2-wire, shielded

Further information: Siehe 'Wiring'.

Cable assembly

Flexible line or wire end ferrule without plastic sheath

Shield connection

 Lay on one end on the module casing

 

Complete KW series

Cross-section

min./max.

0.25 mm² / 0.5 mm²

AWG 24 / AWG 20

Recommended
wire cross-sections

0.5 mm²

AWG 20

Cable stripping length

8 mm

Terminal

FK-MC 0,5/2-ST-2,5