Parameterisation
The EtherCAT interface X60 is parameterised in the instance 7 as follows:
|
Parameter |
Name |
Value |
Description |
|---|---|---|---|
|
ID34140 |
'AS BUS protocol' |
2B*) |
Ethernet 2 |
|
ID34143 |
'Usage port' |
4*) |
Software AIPEX PRO (CODESYS) |
|
ID34023 |
'BUS address participant' |
0x0101*) |
The Ethernet IP address is set in the IDs ID34023 and ID34026. An Ethernet address of 0xaa.0xbb.0xcc.0xdd. results in the following ID assignment: ID34023: 0xccdd and ID34026: 0xaabb Default setting: 192.168.1.1 |
|
ID34025 |
'BUS mode' |
|
|
|
Bit 3: |
0*) |
Ethernet class C network (subnet mask: 255.255.255.0) |
|
|
1 |
Ethernet class B network (subnet mask: 255.255.0.0) |
||
|
ID34026 |
'BUS mode attribute' |
0xC0A8*) |
see ID34023 |
|
ID34057 |
'Network mask' |
0x00FFFFFF |
ID34057 is used to set the network mask. Conditions similar to those for the ID34056 gateway address apply here. Example: 0x00FFFFFFh = 255.255.255.0. class C network. When using ID 34057, bit 3 must be equal to 0 in ID34025. |
|
*) |
Default setting |
|
|
The two Ethernet interface X20 and X60 may not be assigned to the same network segment. Different network segments are on hand when the interfaces have been assigned different network classes or different segment addresses. Example 1: The interface X20 is set as a class B network and X60 as a class C network. Example 2: X20 is a class C network with an address of 192.198.0.1 and X60 is a class C network with an address of 192.198.1.1. |
For more information about the parameter properties, see 'Parameter description', AMK part-no. 203704.
